Driver Airbag - Installation

INSTALLATION





NOTE: When replacing a driver airbag, the new airbag will come with the trim cover and horn switch included. If undeployed, they need not be transferred to the new driver airbag.

1. Connect the two squib connectors (2) to the back of the driver airbag (3).
2. Install the driver airbag into the steering wheel cavity.
3. Install the two retaining bolts (5) to the driver airbag (3) in the rear of the steering wheel. Tighten bolts to 10 Nm (89 in. lbs.).

WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE. PERSONAL INJURY OR DEATH MAY RESULT IF THE SYSTEM TEST IS NOT PERFORMED FIRST. FOR THE SYSTEM TEST, Supplemental Restraints Verification Test

4. Close hood.