Throttle Body - Installation

4.0L





1. Inspect and replace throttle body gasket if necessary.
2. Install throttle body gasket.
3. Install throttle body.
4. Install throttle body bolts and hand tighten.




CAUTION: The throttle body must be torqued in a mandatory torque sequence. Tighten in a criss - cross pattern to specification.

5. Tighten the bolts in a mandatory torque criss - cross pattern sequence to 5.5 Nm (50 in. lbs.).
6. Install throttle body air intake hose and tighten clamps.
7. Install the engine cover.




8. Connect electrical connectors and purge line to throttle body.
9. Connect negative battery cable, tighten nut to 5 Nm (45 in. lbs.).
10. Use a scan tool and perform the ETC RELEARN function.