Rear Fascia - Installation

INSTALLATION





1. Place bright chrome molding (2) in position on the upper fascia (1).
2. Using hand pressure, press molding locking tabs in the full lock position.




NOTE: Use care not to scratch the surface of the fascias.

3. Position upper (1) and lower (2) fascia on a clean surface so that locking tabs (3) align with the slots
4. Press the fascias together to lock locking tabs into position.




5. Install park assist sensors (5), if necessary.Park Assist Sensor - Installation.




6. Place bumper fascia into position on vehicle.
7. Stretch fascia around fascia aperture brackets and slide fascia between body side aperture and fascia aperture brackets.
8. Install the two screws (3) attaching the upper fascia in the tail lamp bucket area.
9. Install two screws (5) per side attaching fascia to rear fascia bracket in the wheelhouse.
10. Install the four new push pin fasteners (6) attaching rear fascia to reinforcement bumper. Discard old push pins.




11. Connect park assist sensor wire harness (3) under vehicle, if necessary.




12. Install tail lamps.
13. Lower vehicle.
14. Install two push pin fasteners (2) per side at the liftgate tower area.
15. Close liftgate.