Procedures

REPLACEMENT WIPER MOTOR SYNCHRONIZATION





NOTE: Insure the multifunction switch is in the OFF position before attempting this procedure.

1. Connect the replacement wiper motor harness connector (1) to the Body Control Module (BCM) (2).
2. Connect the battery negative cable.




CAUTION: Be sure to keep the wiper motor clear from surrounding wiper system linkage and unsecured harness connectors.

3. Hold the wiper motor in one hand.
4. Turn the ignition switch to the ON/RUN position.
5. Rotate the multifunction switch to the low position.
6. Rotate the multifunction switch back to the OFF position and wait until the wiper motor stops.
7. Turn the ignition switch to the OFF/LOCK position.
8. Disconnect the negative battery cable.
9. Disconnect the wiper motor harness connector from the BCM.
10. The new wiper motor should now be in the park position (1) and synchronized for wiper motor crank installation.