Installation

INSTALLATION

1. Position the cooler line(s) and loosely connect the fittings.
2. Install the retainers and bolts for the cooler line(s).

NOTE: Replace the copper washers if the banjo bolts are removed.

3. Tighten the cooler line fittings or banjo bolts to 20 Nm (15 ft. lbs.).
4. Tighten the transmission cooler line retaining bolts to 10 Nm (89 in. lbs.).
5. Lower the vehicle.
6. Install the radiator if removed. Radiator - Installation.
7. Check the transmission fluid level. Check Oil Level - NAG1.