Travel Sensor - Removal

REMOVAL





WARNING: THE DIAPHRAGM TRAVEL SENSOR SEALING RING MAY BE SUCKED INTO THE BRAKE BOOSTER IF VACUUM IS PRESENT. IF THIS HAPPENS, THE BRAKE BOOSTER MUST BE REPLACED.

1. Operate the brake pedal several times until the vacuum in the brake booster is reduced.
2. Unplug the BAS diaphragm travel sensor harness connector.
3. Remove the locking ring (1) by using a suitable pick tool to lift the locking ring up and off the BAS diaphragm travel sensor.
4. Pull the BAS diaphragm travel sensor out of the brake booster.
5. Remove the O-ring from the BAS diaphragm travel sensor.