Removal

REMOVAL





1. Before attempting any service procedure refer to the warnings. Service Precautions.
2. Disconnect the negative battery cable (2). Wait two minutes for the system capacitor to discharge before further service.
3. Remove the ignition key.
4. Remove the door trim panel. Door Trim Panel - Removal.




5. Disconnect the side impact airbag squib harness connector (2) from the side impact airbag.

CAUTION: Do not pull on the squib connector wires or pry on the connector insulator to disengage the connector from the side airbag inflator connector receptacle. Improper removal of the squib wires and their connector insulators can result in damage to the airbag circuits or connector insulators.

6. Drill out the mounting rivets (1) for the side impact airbag.
7. Remove the side impact airbag from the door.

WARNING: Do not place an intact undeployed airbag face down on a hard surface, the airbag will propel into the air if accidentally deployed.