Master Cylinder - Installation

LHD MASTER CYLINDER





1. Bleed the master cylinder on a bench. Procedures.
2. Install the O-ring (7) onto the master cylinder (5).
3. Install the master cylinder (5) to the booster (6). Install the mounting nuts. Tighten to 20 Nm (15 ft. lbs.).
4. Install the brake lines (3) to the master cylinder (5). Tighten to 14 Nm (10 ft. lbs.).
5. Connect the fluid level sensor harness connector (2) to the fluid reservoir (1).
6. Fill and bleed the brake system.
- Manual bleeding: Brake Bleeding.
- Pressure bleeding: Brake Bleeding.