Seat Cushion - Installation

INSTALLATION





1. These components are not replaceable separately from the seat cushion foam. When replaced as an assembly, the complete service kit (seat cushion, bladder/sensor, OCM, and new wiring harness) MUST be used Seat Cushion - Removal. Install both springs (1) into the plate springs with the narrow coils pointing downward at an angle and insert into humps on cushion shell (2). Push the seat cushion toward the rear below the seat back.
2. Install the seat cushion at front and install to the seat frame.

NOTE: Insert the connection leads into connector with present leads.

3. Connect the leads for the heated seat cushion to the 4-pin connector if equipped.




NOTE: The expanding anchors and bearing brackets are deleted parts and must be reordered for installation.

4. Install the two expanding anchors (2) into the front left and right bearing bracket (1).




5. Install the front bolt (2).
6. Install the front seat. Seat - Installation.