Powertrain Verification Test - Ver 3

POWERTRAIN VERIFICATION TEST - VER 3

1.

Note: If the PCM has been replaced, the PCM version coding must be updated with the DRBIII

Inspect the vehicle to ensure that all components related to the repair are connected properly. With the DRBIII, clear DTCs and Reset Memory for all engine values. Run the engine for one warm-up cycle to verify operation.

Road test the vehicle. Use all accessories that may be related to this repair. With the DRBIII, confirm that no DTCs are present and that all components are functioning properly. If this test is being performed after a No Trouble Code test, verify the symptom is no longer present. If the symptom is still present, or any other symptom or DTC is present refer to the appropriate category and perform the corresponding symptom. Refer to any Technical Service Bulletins that may apply. If there are no DTCs present and all components are functioning properly, the repair is complete.
Are any DTCs present?
YES >> Repair is not complete, refer to appropriate symptom.
NO >> Repair is complete.