Inspection Procedure 25

INSPECTION PROCEDURE 25: Tape Player: Malfunction of the Auto Reverse.

DIAGNOSIS

STEP 1. Check that the tape player works normally when the tape is changed.

NOTE: Ensure that the tape label is not loose, that the tape itself is not deformed and that the tape is tightly wound. Also, tape of C-120 or greater length often get caught in the mechanism and should not be used.

Q: Does the tape player work normally if the tape is changed?

YES: The tape used is defective. The auto reverse function should operate normally.
NO: Go to Step 2.

STEP 2. Check that the problem only occur while the vehicle is being driven.

Q: Does the problem only occur while the vehicle is being driven?

YES: Go to Step 3.
NO: Repair or replace the tape player. The auto reverse function should operate normally.

STEP 3. Check that the tape player is properly installed to the vehicle.

Q: Is the tape player properly installed to the vehicle?

YES: Repair or replace the tape player. The auto reverse function should operate normally.
NO: Repair the installation condition. The auto reverse function should operate normally.