Instrument Cluster Bezel Replacement

REMOVAL

Fig. 1 Negative Battery Cable Remote Terminal:

1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
2. Remove the instrument panel left end cap.
3. Remove steering column shroud cover.
4. Tilt the steering column down into the lowest position.
5. Remove one screw (Concorde/300M) to cluster bezel
6. Remove the items to expose bezel mounting screws.Items vary depending on model.
7. Remove two screws over upper cluster bezel in instrument panel brow area and all remaining attaching screws.
8. Using a trim stick (special tool #C-4755), gently pry out on the instrument panel cluster bezel, disconnect headlamp switch connector, and remove.

INSTALLATION
1. Connect headlamp switch connector.Place the cluster bezel into position and snap it into place firmly.
2. Install the two screws over upper cluster bezel in instrument panel brow area and all remaining attaching screws.
3. Install the items covering the bezel mounting screws.
4. Install the one screw (Concorde/300M) to cluster bezel

To service any instrument cluster component, the instrument cluster must be removed from the instrument panel. Use the following procedure:
5. Tilt the steering column down into the highest position.
6. Install the steering column shroud cover.
7. Install the instrument panel left end cap.
8. Connect the negative battery cable remote terminal to the remote battery post.