Verification Test VER-3A

VERIFICATION TEST VER-3A

Applicability - All

1. Charging Verification

2. Note: If the PCM has been changed and the correct VIN and mileage have not been programmed, a DTC will be set in the ABS and Airbag modules. In addition, if the vehicle is equipped with a Sentry Key Immobilizer Module (SKIM), Secret Key data must be updated to enable starting.

3. For ABS and Airbag Systems: ACTION: Enter correct VIN and mileage in PCM. Erase codes in ABS and Airbag modules.

4. For SKIM Theft Alarm: ACTION:

5. Connect the DRB III to the Data Link Connector.

6. Go to Theft Alarm, SKIM, Misc. and place SKIM in secured access mode, by using appropriate PIN code for vehicle.

7. Select Update Secret Key data. Data will be transferred from SKIM to PCM.

8. Inspect the vehicle to ensure that all engine components are connected. Reassemble and reconnect components as necessary.

9. Connect the DRB III to the PCM Data Link Connector and erase codes.

10. Note: Ensure no other Charging System problems remain by doing the following:

11. Start the engine.

12. Perform generator output test.

13. Raise the engine speed to 2000 rpm for at least 30 seconds.

14. Allow the engine to idle.

15. Turn the engine OFF.

16. Turn the ignition key ON.

17. With the DRB, read trouble code messages.

18. If the repaired code has reset, or any other one has set, check all pertinent Technical Service Bulletins and return to the symptom list and restart diagnostic testing for this symptom if necessary.

19. If there are no codes, the repair is now complete.