Rear Crankshaft Main Bearing Seal: Service and Repair

1. With transaxle separated from engine, pry out rear seal with screwdriver. Do not nick or damage crankshaft flange seal surface or retainer bore.
2. Inspect shaft seal surface for nicks or dirt. Polish with 400 grit sandpaper if necessary.
3. Reverse procedure to install, noting the following:
a. Seal should be installed dry, with "THIS SIDE OUT" mark facing away from block.
b. Use pilot tool No. 6926-1, seal installation tool No. 6926-2 and handle tool No. C-4171, or equivalents, to install seal. Do not drive seal beyond flush with block surface.