DR-11A Fault Code 35 Radiator Fan Relay

1. Connect diagnostic read-out tool to engine harness connector, then a voltmeter to dark blue/pink of radiator fan relay small 3-way connector and to ground.
2. Entry system into ATM Test Mode Code 04.
3. If voltmeter is not pulsating but is indicating voltage is within one volt of battery voltage, proceed to Test 11 step B. DR-11B Radiator Fan Relay Control Wire
4. If voltmeter is pulsating between between zero and five volts, proceed to Test 11 step C. DR-11C Radiator Fan Relay Pull-In Coil Windings
If voltmeter is not pulsating but is indicating voltage is zero to one volt, disconnect logic module red connector and proceed as follows:
a. If voltage is now within one volt of battery, replace logic module.
b. If voltage is not within one volt of battery, repair short to ground in dark blue/pink wire.