Parking Brake Rear Cable Replacement - Right Side (J90, J96 Chassis Cab)

Parking Brake Rear Cable Replacement - Right Side (J90, J96 Chassis Cab)

Removal Procedure

1. Release the park brake.

2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.





3. Drill a 3 mm (1/8 in) hole through the dimple in the right parking brake cable connector (1) where the front parking brake cable is connected.

4. Pull the parking brake equalizer forward and disconnect the right parking brake cable connector from the intermediate parking brake cable.

5. Compress the locking tabs on the right parking brake cable conduit (2) and remove the parking brake cable from the equalizer.





6. Pull the right parking brake cable (1) through the frame bracket and over the rear stabilizer bar link.





7. Remove the parking brake cable (1) from the retaining clip on the rear axle housing cover.





8. Remove the bolt (1) from the parking brake cable bracket.





9. Disconnect the parking brake cable eye (1) from the parking brake actuator lever.

10. Remove the parking brake cable from the cable bracket by compressing the parking brake cable spring toward the cable eye and passing the cable through the cable bracket slot.

11. Remove the parking brake cable.

Installation Procedure

1. Position the parking brake cable to the vehicle.





2. Connect the parking brake cable eye (1) to the parking brake actuator lever.

3. Install the parking brake cable to the cable bracket by compressing the parking brake cable spring toward the cable eye and passing the cable through the cable bracket slot.

4. Ensure the parking brake cable conduit is fully seated in the cable bracket.





Caution:
Refer to Fastener Caution Fastener Caution.

5. Install the bolt (1) to the parking brake cable bracket and tighten to 22 Nm (16 lb ft).





6. Install the parking brake cable (1) to the retaining clip on the rear axle housing cover.





7. Route the right parking brake cable (1) over the rear stabilizer bar link and through the frame bracket.





8. Pull the parking brake equalizer forward and install the right parking brake cable connector (1) to the intermediate parking brake cable.

9. Compress the locking tabs on the right parking brake cable conduit (2) and install the parking brake cable to the equalizer.

10. Adjust the parking brake. Refer to Parking Brake Adjustment (1500 Drum Brake Without TZ0) AdjustmentsParking Brake Adjustment (3500 DRW Without TZ0) AdjustmentsParking Brake Adjustment (2500/3500 SRW Without TZ0) AdjustmentsParking Brake Adjustment (1500 Disc Brake Without TZ0) AdjustmentsParking Brake Adjustment (1500 Drum Brake With TZ0) AdjustmentsParking Brake Adjustment (1500 Disc Brake With TZ0) Adjustments.