Parking Brake Rear Cable Replacement - Left Side (JD9)

Parking Brake Rear Cable Replacement - Left Side (JD9)

Removal Procedure




1. Release the park brake.

2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

3. Loosen the intermediate park brake cable equalizer nut (1).




4. Disconnect the left rear park brake cable (1) from the equalizer.

5. Release the left park brake cable from the frame bracket by compressing the locking tabs and pulling the cable conduit rearward.




6. Remove the park brake cable clip bolt.




7. Release the park brake cable from the rear axle bracket by compressing the locking tabs and pulling the park brake cable conduit (1) rearward.

8. Disconnect the park brake cable eye (2) from the park brake actuator lever.

9. Remove the park brake cable assembly from the vehicle.

Installation Procedure




1. Connect the left park brake cable eye (2) to the park brake actuator lever.

2. Install the park brake cable to the rear axle bracket by pulling the cable conduit (1) rearward and inserting the cable conduit into the rear axle bracket.
Ensure the locking tabs on the cable conduit are fully engaged into the rear axle bracket.





Caution: Refer to Fastener Caution Fastener Caution.

3. Install the park brake cable clip bolt.

Tighten the bolt to 22 Nm (16 lb ft).




4. Connect the left rear park brake cable (1) to the equalizer.

5. Insert the park brake cable conduit into the frame bracket.
Ensure the locking tabs on the cable conduit are fully engaged into the frame bracket.

6. Adjust the park brake. Refer to Parking Brake Adjustment (1500 Drum Brake Without TZ0) AdjustmentsParking Brake Adjustment (3500 DRW Without TZ0) AdjustmentsParking Brake Adjustment (2500/3500 SRW Without TZ0) AdjustmentsParking Brake Adjustment (1500 Disc Brake Without TZ0) AdjustmentsParking Brake Adjustment (1500 Drum Brake With TZ0) AdjustmentsParking Brake Adjustment (1500 Disc Brake With TZ0) Adjustments.