Shock Absorber Replacement (4WD)

Shock Absorber Replacement (4WD)

Removal Procedure




1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

2. Support the lower control arm with a jack stand.




3. Remove the shock absorber upper retaining nut and bushing.




4. Remove the shock absorber lower mounting bolt.

5. Remove the shock absorber.

Installation Procedure




1. Install the shock absorber. Insert the stem through the hole in the shock tower.

2. Align the shock absorber with the mounting holes in the lower control arm.

Caution: Refer to Fastener Caution Fastener Caution.

3. Install the shock absorber lower mounting bolt and nut and tighten to 80 Nm (59 lb ft).




4. Install the shock absorber upper retaining nut and bushing and tighten to 22 Nm (16 lb ft).

5. Remove the safety stands.

6. Lower the vehicle.

7. Dispose of the shock absorber. Refer to Shock Absorber Disposal Shock Absorber Disposal.