Positive: Service and Repair

Battery Positive Cable Replacement (LEA)

Removal Procedure

1. Record all of the radio station presets.

2. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection Battery Negative Cable Disconnection and Connection.





3. Remove the battery positive post clamp nut (2).

4. Remove battery positive terminal (1) at the fuse block.

5. Disconnect retainers (3) holding battery positive cable (4).





6. Remove generator nut (1) from the generator B+ stud.

7. Remove the starter solenoid nut (2).

8. Remove the battery positive (Starter) cable (4) and the battery positive (Generator) cable (5) from the vehicle.

9. Remove the retainers (3) holding the battery positive cables to the engine.

Note:
Observe how the battery positive cable was routed within the engine compartment.

Installation Procedure





Caution:
Refer to Fastener Caution Fastener Caution.

1. Install the battery positive cable nut (2) to the B+ generator stud and tighten to 20 Nm (15 lb ft).

2. Install battery positive cable nut (2) and terminals (Starter/Generator),to the starter solenoid.Tighten to 10 Nm (88 lb in)

3. Install retainers (3) to the engine.





4. Install the battery positive cable terminal nut (1) to the fuse block and tighten to 16 Nm (12 lb ft).

5. Install battery positive cable clamp nut (2) to the battery post and tighten to 10 Nm (88 lb in)

6. Install engine control module (ECM) and battery cover.

7. Reset the radio channel presets.