Electronic Brake Control Module: Testing and Inspection

Electronic Brake Control Module Programming and Setup

EBCM Replacement

If the electronic brake control module (EBCM) is replaced, the following procedures must be performed:

EBCM Reprogramming, refer to Service Programming System (SPS) Service Programming System (SPS).

EBCM Reprogramming

If the EBCM needs to be reprogrammed, refer to Service Programming System (SPS) Service Programming System (SPS).

Setup for Component Replacement

The replacement of some ABS components will require a setup procedure for complete repair.

If any of the following components are replaced, the corresponding procedure must be performed.

Steering Angle Sensor

Calibrate the steering angle sensor. Refer to Steering Angle Sensor Centering Procedures.

Brake Pressure Modulator Valve Assembly

Calibrate the brake pressure sensor. Refer to Brake Pressure Modulator Valve Pressure Sensor Calibration Testing and Inspection.