Battery Positive Cable Replacement (Primary)

Battery Positive Cable Replacement (LGH - Primary)

Removal Procedure

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection Battery Negative Cable Disconnection and Connection.

2. Disconnect the positive battery cable from the battery.





3. Remove the positive cable nut from the junction block and disconnect the cable.





4. Remove the positive cable nut from the generator and disconnect the cable.

5. Remove the engine cover. Refer to Engine Cover Replacement Service and Repair.





6. Disconnect the wiring harness clips and the positive cable from the glow plug module.

7. Remove the battery positive cable from the engine harness clip.





8. Remove the battery positive cable from the engine harness clips (1).

9. Raise the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.





10. Remove the battery positive cable bolt (1) and clip (2) from the frame.

11. Remove the battery positive cable retaining clip from the transmission line bracket.





12. Remove the positive battery cable nut (7) from the starter and disconnect the cable (8).

13. Remove the positive battery cable.

Installation Procedure

1. Position the positive cable to the vehicle using the same cable routing as in removal.





Caution:
Refer to Fastener Caution Fastener Caution.

2. Position the positive cable (8) to the starter and install the nut (7) and tighten to 10 Nm (89 lb in).

3. Install the positive cable retaining clip to the transmission line bracket.





4. Install the battery positive cable nut (1) and clip (2) to the frame.

5. Lower the vehicle.





6. Install the positive cable to engine harness clips (1).

7. Install the positive cable to the engine harness clip.





8. Connect the positive cable to the glow plug module and connect the wiring harness clips.

9. Install the engine cover. Refer to Engine Cover Replacement Service and Repair.





10. Install the positive battery cable to the generator and tighten the nut 10 Nm (89 lb in).





11. Install the positive cable to the junction block and tighten the nut to 8 Nm (71 lb in).

12. Connect the positive cable to the battery and tighten the terminal to 14 Nm (123 lb in).

13. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection Battery Negative Cable Disconnection and Connection.