Transmission Front Mount Replacement

Transmission Front Mount Replacement

Removal Procedure

Warning

Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a hoist, provide additional support for the vehicle on the opposite end from which the components are being removed.

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

2. Remove the engine protection shield. Refer to Engine Splash Shield Replacement.

3. support the powertrain with a suitable jack stand.





4. Remove the front transmission mount to frame bolt (1).





5. Remove the front transmission mount to transmission bolts (1).

6. Remove the front transmission mount (2).

Installation Procedure





1. Install the front transmission mount (2).

Caution:
Refer to Fastener Caution Fastener Caution.

2. Install the front transmission mount to transmission bolts (1) and tighten to 50 Nm (37 lb ft).





3. Install the front transmission mount to frame bolt (1) and tighten to 100 Nm (74 lb ft).

4. Remove the jack stand supporting the powertrain.

5. Install the engine protection shield. Refer to Engine Splash Shield Replacement.

6. Lower the vehicle.