Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left Side) Intake

CAMSHAFT POSITION ACTUATOR SOLENOID VALVE SOLENOID REPLACEMENT - BANK 2 (LEFT SIDE) INTAKE

Removal Procedure






1. Remove the engine mount strut bracket. Service and Repair

2. Remove the radiator inlet hose from the water outlet. Service and Repair

3. Remove the power steering fluid reservoir bracket bolts (1).

4. Remove and reposition the power steering fluid reservoir bracket (2) out of the way.






5. Disconnect the engine wiring harness electrical connector (6) from the bank 2 intake camshaft position (CMP) actuator solenoid valve.






6. Remove the CMP actuator solenoid valve bolt and valve (3).

7. Inspect the CMP actuator solenoid valve seal for damage and replace as necessary.

Installation Procedure






1. Inspect the CMP actuator solenoid valve seal for damage. Replace the seal if necessary.

Caution: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Do not use paints, lubricants, or corrosion inhibitors on fasteners, or fastener joint surfaces, unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems. When using fasteners that are threaded directly into plastic, use extreme care not to strip the mating plastic part(s). Use hand tools only, and do not use any kind of impact or power tools. Fastener should be hand tightened, fully seated, and not stripped.

2. Install the CMP actuator solenoid valve (3) and bolt.

Tighten the bolt to 10 Nm (89 lb in).






3. Connect the engine wiring harness electrical connector (6) to the bank 2 intake CMP actuator solenoid valve.






4. Position and install the power steering fluid reservoir bracket (2).

5. Install the power steering fluid reservoir bracket bolts (1).

Tighten the bolts to 9 Nm (80 lb in).

6. Install the radiator inlet hose to the water outlet. Service and Repair

7. Install the engine mount strut bracket. Service and Repair