Rear Brake Caliper Bracket Replacement (With Single Rear Wheel)

Rear Brake Caliper Bracket Replacement (With Single Rear Wheel)
Warning: Refer to Brake Dust Warning (Brake Dust Warning).

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (Service and Repair).

Caution: Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which may cause damage to the brake hose and in turn may cause a brake fluid leak.

3. Remove the brake caliper from the brake caliper mounting bracket and support the brake caliper with heavy mechanic's wire or equivalent. DO NOT disconnect the hydraulic brake hose from the brake caliper. Refer to Rear Brake Caliper Replacement (With Single Rear Wheel) (Rear Brake Caliper Replacement (With Single Rear Wheel))Rear Brake Caliper Replacement (Dual Rear Wheel) (Rear Brake Caliper Replacement (Dual Rear Wheel)).




4. Remove the brake pads from the brake caliper mounting bracket.
5. Remove the anti-rattle clips from the brake caliper bracket.




6. Remove the brake caliper bracket mounting bolts (2).
7. Remove the brake caliper bracket (1).
8. Remove any contaminants or foreign material from the inside ends of the brake caliper bracket.
9. Clean the mounting surface and threads of the brake caliper bracket.

Installation Procedure




1. Install the brake caliper bracket (1).
2. Perform the following procedure before installing the brake caliper bracket mounting bolts.

1. Remove all traces of the original adhesive patch.
2. Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
3. Apply threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolt.

Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the caliper bracket mounting bolts (2).

* JH5: Tighten the bolts to 200 Nm (148 lb ft).
* JH6, JH7: Tighten the bolts to 165 Nm (123 lb ft).




4. Install the anti-rattle clips to the brake caliper mounting bracket.
5. Install the brake pads to the brake caliper mounting bracket.
6. Slide the brake pads in until they contact the rotor.
7. Install the brake caliper. Refer to Rear Brake Caliper Replacement (With Single Rear Wheel) (Rear Brake Caliper Replacement (With Single Rear Wheel))Rear Brake Caliper Replacement (Dual Rear Wheel) (Rear Brake Caliper Replacement (Dual Rear Wheel)).
8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (Service and Repair).
9. Lower the vehicle.
10. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
11. Slowly release the brake pedal.
12. Wait 15 seconds, then repeat steps 10-11 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.