4L60-E/4L65-E/4L70-E - Automatic Transmission

Control and Shift Solenoids Replacement

Removal Procedure





1. Remove the transmission oil pan and filter. Refer to Automatic Transmission Fluid and Filter Replacement (Removal and Replacement) .

Important: Do not remove the valve body for the following procedures. Removal of the 1-2 accumulator is necessary only if servicing the pressure control solenoid.


2. Remove the 1-2 accumulator if necessary. Refer to Accumulator Assembly, Spacer Plate, and Gaskets (4L60-E/4L65-E/4L70-E - Automatic Transmission) .
3. Disconnect the internal wiring harness electrical connectors from the following components:

* Transmission fluid pressure switch (1)
* 1-2 shift control solenoid (2)
* 2-3 shift control solenoid (3)
* Pressure control solenoid (4)
* TCC PWM solenoid (5)
* 3-2 control solenoid (6)





4. Remove the pressure control solenoid retainer.
5. Remove the pressure control solenoid.




6. Remove the 1-2 and 2-3 shift solenoid retainers.
7. Remove the 1-2 and 2-3 shift solenoids.




8. Remove the 3-2 control solenoid retainer.
9. Remove the 3-2 control solenoid.



Installation Procedure





1. Install the 3-2 control solenoid.
2. Install the 3-2 control solenoid retainer.




3. Install the 1-2 and 2-3 shift solenoids.
4. Install the 1-2 and 2-3 shift solenoid retainers.




5. Install the pressure control solenoid.
Ensure that the electrical tabs are facing outboard.
Notice: Refer to Fastener Notice .


6. Install the pressure control solenoid retainer and retaining bolt.

Tighten the pressure control solenoid retaining bolt to 11 N.m (97 lb in).





7. Connect the internal wiring harness electrical connectors to the following components:

* Transmission fluid pressure switch (1)
* 1-2 shift control solenoid (2)
* 2-3 shift control solenoid (3)
* Pressure control solenoid (4)
* TCC PWM solenoid (5)
* 3-2 control solenoid (6)

8. Install the 1-2 accumulator. Refer to Accumulator Assembly, Spacer Plate, and Gaskets (4L60-E/4L65-E/4L70-E - Automatic Transmission) .
9. Install the transmission oil pan and filter. Refer to Automatic Transmission Fluid and Filter Replacement (Removal and Replacement) .
10. Fill the transmission to the proper level with DEXRON(R) VI transmission fluid. Refer to Transmission Fluid Check (4L60-E/4L65-E/4L70-E Automatic Transmission) .

Important: It is recommended that transmission adaptive pressure (TAP) information be reset.


Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.


11. Reset the TAP values. Refer to Transmission Adaptive Functions (Transmission Adaptive Functions) .