(W/NYS)

Brake Caliper Bracket Replacement Rear (W/NYS)

Caution: Refer to Brake Dust Caution in Service Precautions.

Removal Procedure
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting..
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.





3. Remove the nut and the bolt from the quarter shaft shield.
4. Remove the shield.





5. Remove the 2 brake caliper mounting bolts.

Notice: Support the brake caliper with heavy mechanic's wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which may cause damage to the brake hose and in turn may cause a brake fluid leak.

6. Remove the brake caliper and support with heavy mechanic's wire or equivalent. DO NOT disconnect the hydraulic brake hose from the brake caliper.





7. Remove the 2 brake caliper mounting bracket bolts.





8. Remove the disc brake pads from the brake caliper mounting bracket.
9. Remove the anti-rattle clips from the brake caliper mounting bracket.

Installation Procedure





1. Install the anti-rattle clips to the brake caliper mounting bracket.
2. Install the disc brake pads to the brake caliper mounting bracket.





3. Perform the following procedure before installing the 2 brake caliper mounting bracket bolts.
^ Remove all traces of the original adhesive patch.
^ Clean the threads of the bolts with brake parts cleaner or the equivalent and allow to dry.
^ Apply Threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolts.

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the brake caliper mounting bracket and the 2 brake caliper mounting bracket bolts.
Tighten the 2 brake caliper mounting bracket bolts to 200 Nm (148 ft. lbs.).





5. Perform the following procedure before installing the 2 brake caliper mounting bolts.
^ Remove all traces of the original adhesive patch.
^ Clean the threads of the bolts with brake parts cleaner or the equivalent and allow to dry.
^ Apply Threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolts.

6. Install the brake caliper to the brake caliper mounting bracket.

Notice: Refer to Fastener Notice in Service Precautions.

7. Install the 2 brake caliper mounting bolts.
Tighten the 2 brake caliper mounting bolts to 42 Nm (31 ft. lbs.).





8. Install the quarter shaft shield.
9. Install the quarter shaft shield nut and the bolt.
Tighten the quarter shaft shield nut and the bolt to 25 Nm (18ft. lbs.).
10. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
11. Lower the vehicle.
12. With the engine OFF gradually apply the brake pedal to approximately 2/3 of it's travel distance.
13. Slowly release the brake pedal.
14. Wait 15 seconds then repeat steps 13, 14 and 15 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.