Canister Purge Solenoid: Service and Repair

EVAPORATIVE EMISSION (EVAP) CANISTER PURGE SOLENOID VALVE REPLACEMENT

REMOVAL PROCEDURE




1. Remove the engine sight shield.
2. Remove the evaporative emission (EVAP) line from the canister purge solenoid, perform the following:
1. Push the large size white retainer portion in.
2. Push down, while pulling up slightly in order the disengage the tube.




3. Disconnect the EVAP canister purge solenoid electrical connector (1).




4. Remove the EVAP canister purge solenoid bolt (2).
5. Remove the EVAP canister purge solenoid (3) and insulator (1).

INSTALLATION PROCEDURE




1. Install the insulator (1) onto the EVAP canister purge solenoid (3).
2. Install the EVAP canister purge solenoid (3).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the EVAP canister purge solenoid bolt (2).

Tighten the bolt to 10.5 N.m (93 lb in).




4. Connect the EVAP canister purge solenoid electrical connector (1).




5. Install the EVAP line to the canister purge solenoid (1).
6. Install the engine sight shield.