Transfer Case Output Shaft Seal Replacement- Rear

Transfer Case Output Shaft Seal Replacement- Rear
^ Tools Required
- J 45756 Output Shaft Seal Installer

Removal Procedure





1. Raise and suitably support the vehicle. Refer to Vehicle Lifting in Service Precautions.
2. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement.
3. Remove the rear propeller shaft.
4. Remove the rear output shaft seal by prying it out with a flat tipped screwdriver.

Installation Procedure





1. Using J 45756, install a NEW front output shaft seal.
2. Install the rear propeller shaft.
3. Check the fluid level. Add fluid, if necessary.
4. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement.
5. Lower the vehicle.