P0705

DTC P0705

Circuit Description
The transmission range switch sends gear position signals to the Powertrain Control Module (PCM) according to the manual selector range position. The PCM uses this information in order to manage transmission operation.

Conditions for Setting the DTC
^ The transmission range switch signal (R, N, D, 2 or L) does not input for 25 seconds at 60 km/h (38 mph) or higher vehicle speed in DRIVE range.
^ Multiple signals input simultaneously for 25 seconds.
^ Two driving cycle detection logic

Action Taken When the DTC Sets
^ DTC P0705 stores.
^ The PCM enters fail-safe mode.
^ The Malfunction Indicator Lamp (MIL) turns ON. During fail-safe mode operation, the PCM controls the shift solenoids and the Torque Converter Clutch (TCC) solenoid based on the DRIVE range when no signal inputs from the transmission range switch are seen.

Diagnostic Aids
Inspect for the following conditions:
^ The transmission range switch is out of adjustment.
^ A transmission range switch malfunction exists.
^ The following faulty electrical circuits exist between the transmission range switch and the PCM:
- An open
- A short to voltage
- A short to ground
^ A faulty PCM exists. The following conditions may cause an intermittent condition:
^ A reduced connection
^ Rubbed through wire insulation
^ A broken wire inside the insulation

Inspect the PCM harness connectors for the following conditions:
^ Backed out terminals
^ Improper mating
^ Broken locks
^ Improperly formed or damaged terminals
^ Reduced terminal-to-wire connections

If DTC P0705 cannot duplicate, the information included in the Freeze Frame data may be useful in determining the vehicle operating conditions when the DTC set.

Refer to wiring Repairs in Wiring Systems when repairing any wiring.

Test Description
The numbers below refer to the step numbers on the diagnostic table.
1. The Powertrain OBD System Check prompts the technician to complete some basic checks and store the freeze frame data on the Scan Tool if applicable. The scan tool creates an electronic copy of the data taken when the fault occurred. The information then stores in the Scan Tool for later reference.
2. This step tests the transaxle range switch in the P range.
3. This step tests the transaxle range switch in the R range.
4. This step tests the transaxle range switch in the N range.
5. This step tests the transaxle range switch in the D range.
6. This step tests the transaxle range switch in the 2 range.
7. This step tests the transaxle range switch in the L range.
9. This step tests for a faulty PCM.
11. This step tests for an open in the transmission sense circuit between the PCM and the transmission range switch.

Steps 1 - 9:

Steps 10 - 14:

DTC P0705