Seat Cushion Cover and Pad Replacement - Front

Seat Cushion Cover and Pad Replacement - Front

Removal Procedure

1. If equipped with a power seat adjuster, raise the seat to the full up position.
2. Remove the front seat from the vehicle. Refer to Seat Replacement (Seat Replacement) .




3. Remove the seat back cover enough to expose the recliner mechanism bolts (2,7). Refer to Seat Back Cover and Pad Replacement - Front (Seat Back Cover and Pad Replacement - Front) .
4. Remove the recliner bolts (2,7).
5. Remove the seat back (1) from the seat assembly.




6. Remove the seat cushion from the seat adjuster assembly (4).

1. Remove the recliner handle. Refer to Seat Back Recliner Handle Replacement - Front (Seat Back Recliner Handle Replacement - Front) .
2. Remove the power seat adjuster switch, if equipped. Refer to Seat Switch Replacement - Power (Service and Repair) .
3. Remove the bolts securing the seat cushion frame (3) to the adjuster assembly (4).

7. Release the seat cushion J channel retainers from the seat cushion frame.
8. Release the hook and loop strips that retain the seat cushion cover (1) to the seat cushion pad (2).
9. Remove the seat cushion cover from the foam pad.
10. Remove the foam pad (2) from the cushion frame (3).



Installation Procedure





1. When replacing a seat cushion pad (2) on a seat equipped with a power adjuster, remove the perforated section (9) on the front of the cushion pad (2).
2. Position the foam pad (2) to the seat cushion frame (3).
3. Position the seat cushion cover (1) to the foam pad (2).
4. Engage the J channel retainers to secure the seat cushion cover (1) to the seat cushion frame (3).
5. When replacing a seat cushion cover on a seat equipped with a power seat adjuster proceed with the following steps:





1. Locate the opening (1) for the power seat switch within the bracket, through the cover.
2. Using a razor blade make a "X" cut (2) within the opening of the switch bracket.

6. Install the power seat switch. Refer to Seat Switch Replacement - Power (Service and Repair) .




7. Locate the position of the recliner mechanism rod (6) through the cushion cover.
8. Make a small "X" cut just large enough for the recliner rod (6) to go through.
9. Slip the cover over the recliner mechanism rod (6).
10. Install the recliner handle. Refer to Seat Back Recliner Handle Replacement - Front (Seat Back Recliner Handle Replacement - Front) .
11. Position the seat back to the seat cushion assembly.

Notice: Refer toFastener Notice in Cautions and Notices.

12. Install the bolts (3,7).

Tighten the bolts to 32 N.m (24 lb ft).





13. Position the seat assembly to the seat adjuster assembly (4).
14. Install the bolts to secure the seat assembly to the adjuster (4).

Tighten the bolts to 25 N.m(18 lb ft).

15. Install the seat into the vehicle. Refer to Seat Replacement (Seat Replacement) .