Instrument Panel Storage Compartment - Door Replacement

INSTRUMENT PANEL COMPARTMENT DOOR REPLACEMENT

Removal Procedure







1. Remove the right side instrument panel sound insulator. Refer to Service and Repair

2. Push up on the J-spring in order to release the storage compartment door.






3. Remove the screws that retain the instrument panel compartment door hinges to the instrument panel.






4. Remove the screws that retain the instrument panel compartment bezel to the instrument panel.

5. Remove the instrument panel compartment bezel from the instrument panel.

6. Disconnect the electrical connectors from the instrument panel compartment lamp and switch assembly.


Installation Procedure






1. Connect the electrical connector to the instrument panel compartment lamp and switch assembly.

2. Install the storage compartment bezel to the instrument panel.

NOTICE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring or fasteners requiring the use of the thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the screws that retain the instrument panel compartment bezel to the instrument panel.

4. Tighten the screws to 1.9 Nm (17 lb.in).






5. Install the instrument panel storage compartment door to the instrument panel.

6. Install the screws that retain the instrument panel compartment door hinges to the instrument panel.

7. Tighten the screws to 1.9 Nm (17 lb.in).






8. Push the storage compartment into place.

9. Install the right side instrument panel sound insulator. Refer to Service and Repair