Transmission Control Replacement

Transmission Control Replacement

Removal Procedure

1. Remove the front floor console. Refer to Front Floor Console Replacement Front Floor Console Replacement.





2. Slide the shift cable retaining clip (1) toward the front of the vehicle.

3. Disconnect the shift cable (2) from the shift control actuator pin (3).

4. Slide the shift cable (2) upward to remove from shift control base (4).





5. Disconnect the electrical connector (1) from the shift control assembly.

6. Disconnect the wiring harness retainers (2) from the shift control assembly.

7. Remove the inflatable restraint sensing and diagnostic module. Refer to Inflatable Restraint Sensing and Diagnostic Module Replacement Service and Repair.





8. Remove the four fasteners (1).

9. Remove the shift control assembly from the instrument panel tie bar assembly.

Installation Procedure

1. Install the shift control assembly to the instrument panel tie bar assembly.





Caution:
Refer to Fastener Caution Fastener Caution.

2. Install the shift control assembly fasteners (1) and tighten to 10 Nm (89 lb in).





3. Install the electrical connector (1) to the shift control assembly.

4. Install the wiring harness retainers (2) to the shift control assembly.





5. Install the shift cable (2) in the shift control base (4).

6. Slide the shift cable retaining clip (1) toward the rear of the vehicle.

7. Connect the shift cable (2) to the shift control actuator pin (3).

8. Install the inflatable restraint sensing and diagnostic module. Refer to Inflatable Restraint Sensing and Diagnostic Module Replacement Service and Repair.

9. Install the front floor console. Refer to Front Floor Console Replacement Front Floor Console Replacement.

10. Check transmission for proper operation. If necessary, adjust shift cable. Refer to Range Selector Lever Cable Adjustment Range Selector Lever Cable Adjustment.