Transmission Mount Bracket Replacement - Rear

Transmission Mount Bracket Replacement - Rear

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

2. Using a suitable jack stand, support the rear of the transmission.





3. Remove and DISCARD the rear transmission mount bracket to rear mount through bolt (1).





4. Remove and DISCARD the 3 rear transmission mount bracket to transmission bolts (1).

5. Remove the rear transmission mount bracket (2).

Installation Procedure





1. Install the rear transmission mount bracket (2).

Caution:
Refer to Fastener Caution Fastener Caution.

2. Install the 3 NEW rear transmission mount bracket to transmission bolts (1) and tighten to 100 Nm (74 lb ft) plus 30-45 degrees.





3. Install the NEW rear transmission mount bracket to rear mount through bolt (1) and tighten to 80 Nm (59 lb ft) plus 45-60 degrees.

4. Remove the jack stand.

5. Lower the vehicle.