Ignition Coil: Service and Repair

Ignition Coil Replacement

Special Tools

EN-6009 - Remover and Installer Ignition Module

For equivalent regional tools, refer to Special Tools Tools and Equipment.

Removal Procedure

1. Remove engine sight shield.





2. Disconnect ignition coil wiring harness plug (2) from ignition coil (1).





3. Remove the 2 ignition coil bolts (1).





4. Install EN-6009 - remover/installer (1) to ignition coil (2).

5. Remove the ignition coil.

Installation Procedure

1. Install the ignition coil.





2. Remove EN-6009 - remover (1) from ignition coil (2).





Caution:
Refer to Fastener Caution Fastener Caution.

3. Install the 2 ignition coil bolts (1) and tighten to 8 Nm (71 lb in).





4. Connect ignition coil wiring harness plug (2) to ignition coil (1).

5. Install engine sight shield.