Turbocharger Oil Feed Pipe Replacement

Turbocharger Oil Feed Pipe Replacement

Removal Procedure

1. Open the hood.

2. Disconnect battery negative cable. Refer to Battery Negative Cable Disconnection and Connection Battery Negative Cable Disconnection and Connection.

3. Remove the exhaust manifold heat shield. Refer to Exhaust Manifold Heat Shield Replacement (LUV) Exhaust Manifold Heat Shield ReplacementExhaust Manifold Heat Shield Replacement (LUW) Exhaust Manifold Heat Shield Replacement.





4. Remove the turbocharger oil feed pipe bolt (5).

5. Remove the turbocharger oil feed pipe hollow screw (4) and the 2 seal rings (1) and (3).

6. Remove the turbocharger oil feed pipe (2) and the rubber seal ring.

Installation Procedure

1. Clean the sealing surfaces.





2. Install the turbocharger oil feed pipe (2) along with a NEW rubber seal ring.

3. Install the turbocharger oil feed pipe hollow screw (4) and 2 NEW seal rings (1) and (3).

Caution:
Refer to Fastener Caution Fastener Caution.

4. Install the turbocharger oil feed pipe bolt (5) and tighten to 10 Nm (89 lb in).

5. Tighten the turbocharger oil feed pipe hollow screw to 30 Nm (22 lb ft).

6. Install the exhaust manifold heat shield. Refer to Exhaust Manifold Heat Shield Replacement (LUV) Exhaust Manifold Heat Shield ReplacementExhaust Manifold Heat Shield Replacement (LUW) Exhaust Manifold Heat Shield Replacement.

7. Connect battery negative cable. Refer to Battery Negative Cable Disconnection and Connection Battery Negative Cable Disconnection and Connection.

8. Close the hood.