Range Selector Lever Cable Adjustment

Range Selector Lever Cable Adjustment

Note: Adjust the automatic transmission range selector cable while the transmission and the gear selector are in the Park position only. Failure to do so may cause mis-adjustment.

1. Set the park brake and chock the wheels.

Danger: Always perform the High Voltage Disabling procedure prior to servicing any High Voltage component or connection. Personal Protection Equipment (PPE) and proper procedures must be followed.


The High Voltage Disabling procedure will perform the following tasks:


* Identify how to disable high voltage.

* Identify how to test for the presence of high voltage.

* Identify condition under which high voltage is always present and personal protection equipment (PPE) and proper procedures must be followed.


Failure to follow the procedures exactly as written may result in serious injury or death.


2. Disable the high voltage system. Refer to High Voltage Disabling High Voltage Disabling.




3. Pull the retaining collar (1) forward, then release the range select cable adjuster clip (2) by pushing out on the adjuster clip from the side.
4. Verify the transmission range select lever is in the park position.
5. Verify the transmission shift control lever is in the park position.




6. Depress the adjuster clip (2) locking the adjuster clip completely, then release the retaining collar.
7. Ensure that the cable adjuster is secured.
8. Check the transmission range select lever in all gear selections for proper operation.
9. Enable the high voltage system. Refer to High Voltage Enabling High Voltage Enabling.