Shock Absorber Replacement

Shock Absorber Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair).




3. Support the rear axle with a tall jack stand near the shock absorber.




4. Remove the upper and lower shock bolts.
5. Remove the shock from the vehicle.

Installation Procedure

1. Position the shock absorber to the vehicle.





Caution: Refer to Fastener Caution (Fastener Caution).

2. Install NEW upper and lower shock bolts.

* Tighten the upper bolt to 90 Nm (66 lb ft).
* Tighten the lower bolt to 110 Nm (81 lb ft).

3. Remove the jack stand.
4. Install the wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair).
5. Lower the vehicle.