Evaporative Emission Line Replacement - Chassis to Canister

Evaporative Emission Line Replacement - Chassis to Canister

Removal Procedure




1. Disconnect the evaporative emission (EVAP) purge pipe from the engine purge hose. Refer to Evaporative Emission Line Replacement - Engine to Chassis (Evaporative Emission Line Replacement - Engine to Chassis).
2. Cap or plug the purge pipe and the engine purge hose to prevent contamination.
3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
4. Remove the retaining nuts (1).
5. Disconnect the EVAP line from the plastic retainers (2).




6. Disconnect the quick connect fitting (1). Refer to Plastic Collar Quick Connect Fitting Service (Plastic Collar Quick Connect Fitting Service).
7. Disconnect the EVAP line from the plastic retainers (2).
8. Pull down on the EVAP plastic retainers (3) and remove the EVAP line.

Installation Procedure




1. Install the EVAP line into the plastic retainers (3).
2. Connect the EVAP line to the plastic retainers (2).
3. Connect the quick connect fitting (1). Refer to Plastic Collar Quick Connect Fitting Service (Plastic Collar Quick Connect Fitting Service).




4. Connect the EVAP line to the plastic retainers (2).

Caution: Refer to Fastener Caution (Fastener Caution).

5. Install the retaining nuts (1) and tighten to 10 Nm (89 lb in).
6. Remove the caps or plugs from the purge pipe and the engine purge hose.
7. Connect the purge pipe to the engine purge hose. Refer to Evaporative Emission Line Replacement - Engine to Chassis (Evaporative Emission Line Replacement - Engine to Chassis).