Sunroof / Moonroof Panel: Service and Repair

Sunroof Window Replacement

Removal Procedure

1. Slide the sunshade rearward.

Caution: In order to prevent damage to the paint, mask the roof panel in front of the sunroof opening using masking tape and paper.

2. Cycle the sunroof window to the vent position.




3. Remove the sunroof window screws (1) from the window.

Note: Do NOT scratch the roof surface or the sunroof window.

4. Lift the sunroof window from the sunroof opening.

Installation Procedure




1. Position the sunroof window into the opening.
2. Ensure that the window trade mark is to the rear of the opening and that sunroof window attachment tabs are to the inboard side of the mounting arms.

Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the sunroof window screws (1) to the window. Do not tighten the screws.
Tighten the screws to 4 Nm (35 lb in).
4. Carefully close the sunroof window from the vent position to the full closed position.
5. Adjust the sunroof window. Refer to Sunroof Window Height and Opening Fit Adjustment (Sedan) (Sunroof Window Height and Opening Fit Adjustment (Sedan))Sunroof Window Height and Opening Fit Adjustment (Coupe) (Sunroof Window Height and Opening Fit Adjustment (Coupe)).
6. Close the sunshade.
7. Cycle the sunroof window to ensure proper operation and fit.