Rear Bumper Fascia Replacement (Sedan)

Rear Bumper Fascia Replacement (Sedan)












2.Remove the license lamp. Refer to Rear License Plate Lamp Replacement .

3.Remove the rear wheel liners. Refer to Rear Wheelhouse Panel Liner Replacement .

1Rear Bumper Fascia - Upper Screw (Qty: 2)
Caution:Refer to Fastener Caution .
Tighten 2 N �m (18 lb in)

2Rear Bumper Fascia - Upper Retainer (Qty: 6)Tighten 2 N �m (18 lb in)

3Rear Bumper Fascia Bolt (Qty: 2)
Tip Access the bolt from inside the wheel well.
Tighten 2.5 N �m (22 lb in)

4Rear Bumper Fascia - Lower Retainer (Qty: 4)

5Rear Bumper Fascia

Procedure

1.Pull the sides of the rear fascia at the quarter panel to release the fascia from the brackets.

2.Disconnect the license lamp connector.