Clutch Pedal Assembly: Service and Repair

Clutch Pedal Replacement

Removal Procedure





1. Remove the clutch pedal pivot nut (1).




2. Disconnect the electrical connector (1) from the clutch position sensor (2)




3. Depress the tabs of the clutch master cylinder pushrod retainer and release the clutch pedal from the pushrod.




4. Remove the clutch pedal bracket to front of dash nuts (2).
5. Remove the steering column mounting bolts. Move the steering column enough to have clearance to remove the clutch pedal and pedal bracket assembly. Refer to Steering Column Replacement (Steering Column Replacement) .
6. Remove the clutch pedal assembly (1).



Installation Procedure





1. Install the clutch pedal assembly (1).

Notice: Refer to Fastener Notice .

2. Install the clutch pedal bracket to front of dash nuts (2).

Tighten the nuts to 10 N.m (89 lb in).

3. Move the steering column to the original position and install the mounting bolts. Refer to Steering Column Replacement (Steering Column Replacement) .




4. Install the clutch master cylinder pushrod to the clutch pedal, ensure that the pushrod retainer is fully seated to the pedal.




5. Install the clutch pedal pivot nut (1).

Tighten the nut to 10 N.m (89 lb in).





6. Connect the electrical connector (1) to the clutch position sensor (2)
7. Perform the clutch pedal position sensor learn procedure. Refer to Clutch Pedal Position Sensor Learn (Programming and Relearning) for Getrag 5 speed transmission or Clutch Pedal Position Sensor Learn (Programming and Relearning) for MU3 transmission.