Steering Wheel Replacement (Without SIR)

Steering Wheel Replacement (Without SIR)

Tools Required

* J 1859-A Steering Wheel Puller
* J 36541-A Puller Legs
* KM-210-A Steering Wheel Puller

Removal Procedure





Caution: Refer to Battery Disconnect Caution Battery Disconnect Caution.

1. Disconnect the negative battery cable.
2. Rotate the steering wheel to allow access to the steering wheel horn cap screw. Remove the horn cap screw.
3. Rotate the steering wheel to allow access to the other steering wheel horn cap screw. Remove the horn cap screw.




4. Remove the steering wheel horn cap and disconnect the horn leads.




5. Remove the steering wheel nut and the retaining clip.





Important: In order to install the steering wheel correctly, match-mark the steering column shaft to the steering wheel.


6. Remove the steering wheel using the KM-210-A or the J 1859-A and the J 36541-A (1).
7. Unclip the contact ring from the steering wheel, if necessary.

Installation Procedure




1. Clip the contact ring on the steering wheel, if necessary.
2. Align the match-marks on the steering wheel and the steering column shaft.

Notice: Refer to Fastener Notice Fastener Notice.

3. Install the retaining clip and new steering wheel nut.

Tighten the steering wheel nut to 38 Nm (28 lb ft).




4. Bend the tabs to secure the retaining clip.
5. Connect the horn leads and install the steering wheel horn cap.




6. Rotate the steering wheel to allow access to the steering wheel horn cap screw. Install the horn cap screw.
7. Rotate the steering wheel to allow access to the other steering wheel horn cap screw. Install the horn cap screw.

Tighten both steering wheel horn cap screws to 4.5 Nm (40 lb in).

8. Connect the negative battery cable.