Knee Diverter: Service and Repair

Knee Bolster Replacement

Removal Procedure




1. Remove the coin storage and the screws.
2. Separate the hood release cable from the hood latch release handle.
3. Carefully pull the instrument panel (I/P) under cover until the mounting clips are released and the I/P under cover.




4. Remove the bolts from the driver side knee bolster.
5. Remove the knee bolster.

Installation Procedure





Notice: Refer to Fastener Notice Fastener Notice.

1. Install the knee bolster with the bolts.

Tighten the driver side knee bolster mounting bolts to 10 Nm (89 lb in).




2. Install the I/P under cover.
3. Connect the hood release cable to the hood latch release handle.
4. Install the coin storage and the screws.