Canister Purge Solenoid: Service and Repair

Evaporative Emission Canister Purge Solenoid Valve Replacement

Removal Procedure





Caution: Refer to Battery Disconnect Caution Battery Disconnect Caution.

1. Disconnect the negative battery cable.
2. Disconnect the evaporative emission (EVAP) canister purge solenoid connector.
3. Disconnect the vacuum hoses from the EVAP canister purge solenoid.
4. Remove the EVAP canister purge solenoid bracket bolt from the intake manifold.
5. Unclip the EVAP canister purge solenoid from the mounting bracket.

Installation Procedure




1. Attach the EVAP canister purge solenoid to the mounting bracket.

Notice: Refer to Fastener Notice Fastener Notice.

2. Install the EVAP canister purge solenoid and the mounting bracket to the intake manifold with the bracket bolt.

Tighten the EVAP canister purge solenoid bracket bolt to 5 Nm (44 lb in).

3. Connect the vacuum hoses to the EVAP canister purge solenoid.
4. Connect the EVAP canister purge solenoid connector.
5. Connect the negative battery cable.