Valve Cover: Service and Repair

Camshaft Cover Replacement

Removal Procedure




1. Remove the intake manifold cover.
2. Remove the air cleaner outlet duct.
3. Disconnect the intake (3) and exhaust (2) camshaft position actuator solenoid valve electrical connectors.




4. Remove the ignition coils.
5. Remove the engine harness clips (1, 2) from the cover.




6. Remove the fuel feed line retainers (1, 2) from the engine brackets.




7. Remove the camshaft cover bolts.
8. Remove the camshaft cover.

Installation Procedure





Notice: Refer to Fastener Notice.

1. Install the camshaft cover and bolts.

Tighten the bolts to 10 N.m (89 lb in).




2. Install the ignition coils.
3. Install the engine harness clips (1, 2) to the cover.




4. Install the feed line retainers (1, 2) to the engine brackets.




5. Connect the intake (2) and exhaust (2) camshaft position actuator solenoid valve electrical connectors.
6. Install the air cleaner outlet duct.
7. Install the intake manifold cover.