Fog/Driving Lamp: Service and Repair

Fog Lamp Replacement - Front

Removal Procedure





Caution: Refer to Battery Disconnect Caution Battery Disconnect Caution in Cautions and Notices.

1. Disconnect the negative battery cable.
2. Remove the bolts and the front fog lamp.
3. Disconnect the electrical connector.




4. Remove the fog lamp access cover.
5. Remove the retaining wire.
6. Remove the bulb.

Installation Procedure




1. Install the bulb.
2. Install the retaining wire.
3. Install the fog lamp access cover.




4. Connect the electrical connector.

Notice: Refer to Fastener Notice Fastener Notice in Cautions and Notices.

5. Install the front fog lamp with the bolts.

Tighten the front fog lamp bolts to 4 Nm (35 lb in).

6. Connect the negative battery cable.