Brake Pads Replacement - Front

Brake Pads Replacement - Front

Removal Procedure





Caution: Refer to Lifting and Jacking the Vehicle Service and Repair in Cautions and Notices.

1. Raise and suitably support the vehicle.
2. Remove the front wheels. Refer to Tire and Wheel Removal and Installation Service and Repair in Tires and Wheels.
3. Remove the lower bolt of the caliper assembly retaining frame.

Important: Caliper assembly removal is not necessary to service the brake pads.


4. Pull the caliper piston housing up.
5. Remove the brake pads.

Installation Procedure




1. Measure the minimum lining thickness. Refer to Brake Pad Inspection Testing and Inspection.
2. Install the brake pads into the caliper.
3. Push the piston inward, if needed.

Important: Take care not to damage the piston seal when the piston housing frame is pulled down.


Notice: Refer to Fastener Notice Fastener Notice in Cautions and Notices.

4. Pull down the caliper piston housing and secure it to the retaining frame with the lower bolt.

Tighten the retaining frame-to-caliper housing bolts to 27 Nm (20 lb ft).

5. Install the front wheels. Refer to Tire and Wheel Removal and Installation Service and Repair in Tires and Wheels.
6. Lower the vehicle.