Radio Replacement

Radio Replacement

Removal Procedure

1. Remove the Instrument panel (I/P) center trim. Refer to Instrument Panel Center Trim Panel Replacement (Service and Repair) .




2. Remove the bolts (1) securing the radio to the I/P.
3. Disconnect the electrical connectors.



Installation Procedure





1. Connect the electrical connectors.

Notice: Refer to Fastener Notice (Fastener Notice) .

2. Install the bolts (1) securing the radio the I/P.

Tighten the bolts (1) to 9 N.m (80 lb in).

3. Install the I/P center trim. Refer to Instrument Panel Center Trim Panel Replacement (Service and Repair) .
4. Refer to Control Module References (Programming and Relearning) for programming and setup information.