P1460

Circuit Description
This DTC is used to indicate that the fuel level was low during a misfire or lean condition. If this DTC is present, and no misfire or lean condition is currently present, the vehicle may have simply run low on fuel.

Conditions for Running the DTC
At least one of the following DTCs are set: P0171, P0174, and P0300 through P0306.

Conditions for Setting the DTC
^ Fuel Level signal is less than 11 liters (2.9 gallons).
^ The above condition is met for longer than 30 seconds.

Action Taken When the DTC Sets
The ECM will not illuminate the Malfunction Indicator Lamp (MIL).

Conditions for Clearing the MIL/DTC
^ The DTC clears after forty consecutive warm-up cycles if no failures report by this diagnostic or any other non-emission related diagnostic.
^ The ECM battery voltage is interrupted.
^ The scan tool clears the MIL/DTC.