P0230

Diagram Chart:

Electrical:

CIRCUIT DESCRIPTION

The Fuel Pump relay coil is supplied power via the Engine Controls Power Relay (Switched B+). The Engine Control Module (ECM) controls the relay by grounding the control circuit via an internal solid state device called a driver. The primary function of the driver is to supply the ground for the component being controlled. Each driver has a fault line which is monitored by the ECM. When the ECM is commanding a component on, the voltage of the control circuit should be low (near 0 volts). When the ECM is commanding the control circuit to a component off, the voltage potential of the circuit should be high (near battery voltage). If the fault detection circuit senses a voltage other than what is expected, this DTC will set.

When the ECM detects any reference pulses from the Crankshaft Position sensor, the ECM will enable the fuel pump. The relay is used in order to control the high current flow to the fuel pump. This allows the ECM driver to only have to handle the relatively low current used by the relay.

CONDITIONS FOR RUNNING THE DTC

Short to ground and open circuit:

Tested only during powerdown phase.

Short to battery voltage:

Tested continuously.

CONDITIONS FOR SETTING THE DTC

A short to ground, an open circuit, or a short to battery voltage detected on the control circuit.

ACTION TAKEN WHEN THE DTC SETS

The ECM illuminates the Malfunction Indicator Lamp (MIL) and records the operating conditions in the Freeze Frame on the second consecutive drive trip that the diagnostic runs and fails.

CONDITIONS FOR CLEARING MIL/DTC

^ The ECM turns off the MIL after three consecutive drive trips that the diagnostic runs and does not fail.

^ A History DTC clears after forty consecutive warm-up cycles if no failures report by this diagnostic or any other emission related diagnostic.

^ The ECM battery voltage is interrupted.

^ The scan tool clears the MIL/DTC.

DIAGNOSTIC AIDS

Use the Connector Test Adapter Kit J 35616-A for any test that requires probing the ECM harness connector or a component harness connector. Using this kit will prevent damage to the harness connector terminals.

Check for the following conditions:

^ Poor connections at the ECM or at the component. Inspect the harness connectors for any backed out terminals, improper mating, broken locks, improperly formed or damaged terminals, and poor terminal to wire connection. Refer to Overall Vehicle Information / Diagrams / Diagnostic Aids for Checking Terminal Contact procedure.

^ Misrouted harness. Inspect the harness in order to ensure that the harness is not routed too close to any high voltage wires such as spark plug leads, or too close to any high current devices such as the alternator, the motors, the solenoids, etc.

^ Damaged harness. Inspect the wiring harness for any damage. If the harness appears to be OK, observe the scan tool while moving the related connectors and the wiring harnesses. A change in the display may help in order to locate the fault.

Refer to Symptoms / Intermittents. Testing and Inspection

TEST DESCRIPTION

The number(s) below refer to the step numbers on the diagnostic table:

2. Listen for an audible click when the relay operates. Repeat the commands as necessary.

3. This check can detect a partially shorted coil which would cause an excessive current flow. Leaving the circuit energized for 2 minutes allows the coil to warm up. When warm, the coil may open (amps drop to 0), or short (goes above 0.75 amp).

5. It is important to identity and test the relay coil terminals in order to avoid improper diagnosis.

13. If no trouble is found in the control circuit or the connection at the ECM, the ECM may be damaged, however, this is an extremely unlikely failure.